Precise HHO generator control. Fan Cooled, fully enclosed, Engineered to control up to 30A 12/24V DC
One of the main and most important components to a good HHO gas system is the PWM (Pulse Width Modulator). This little electronic circuit board resides in the EC electronic control box and monitors the electrical pulses flowing throughout the HHO system and regulates the flow so that the best possible hydrogen gas is produced by the on demand hydrogen generator.
If your running any HHO generator you will need a Pulse Width Modulator(PWM) to better control the amperage, prevent your system from overheating and to produce more HHO output. This unit is based on the Stanley Meyer design and uses a self cooling fan to keep the heat sink and the unit cool while in use.
Pulse Width Modulation, is a method of transmitting information on a series of pulses. The PWM, as it applies to HHO generators control, is a way of delivering energy through a succession of pulses, changing the frequency, rather than a continuously varying (analog) signal.
It will allow you to control of the amperage going into the generator in a very easy way. Thia ability keeps the cell running at cool operating temperatures and prolongs the life of the cell while increasing the HHO output.
This is one of the most important gadgets in your HHO system. It keeps the gas water ratio correct to make your engine run smoothly and efficiently by pulsing the current rapidly on and off. This prevents overheating of the HHO generator and keeps things at a manageable temperature.
The PWM is an important part of the brains of your HHO kit. The whole reason to convert to hydrogen as a fuel enhancer is to get the optimum performance out of your engine.
What are the main advantages?
Efficiency. HHO generators will run cooler than standard linear power amps, requiring substantially less heat sink mass;
Amperage control. The control of the amperage going into the generator will be very easy to control. The ability to control the amperage keeps the cell running at cool operating temperatures and prolongs the life of the cell while increasing the HHO output.
Technical specifications
Power supply :12/24 VDC (jumper for selection of voltage operation)
Heat Sink: LM324 and a P80NF5 mosfet
Load voltage : 12/24 VDC / 30A max
Output : Controlled HHO cells (Pulse Width Modulation)
Range : 0 - 100 %
Dimensions: 85 x 45 x 32 mm
Ziehen Sie Produkte hierher oder nutzen Sie die entsprechenden Buttons [Jetzt Kaufen] um Ihren Warenkorb zu füllen.